CoilKit Installation Guide
CoilKit v3 works with any OBD1, OBD2A, or OBD2B ECU.
Hondavert S300 system is not required anymore.
Hondavert S300 system is not required anymore.
If you previously used CoilKit v2, disable coil control in S300 Manager and re-upload the calibration to the ECU.
Remove components from the distributor.

- Cap
- Rotor
- Plastic Shield
- Ignition coil
- Igniter Unit
Install CoilKit PCB

Connect CoilKit to the Distributor

- T - Blue Wire. (unused in OBD2B)
- +12V - Black/Yellow Wire.
- ICM - Yellow/Green Wire.
Use heat-shrink tubing to insulate +12V ring terminal.

Connect the ignition coil wiring harness to the CoilKit PCB.

Install the distributor cap and tighten the screws.

After installing the distributor cap, make sure there is no excess wiring inside.
Gently pull the wiring outward until all slack is removed.
Gently pull the wiring outward until all slack is removed.
Install the T-tap connector on the distributor’s CYP+ wire.

Use pliers to crimp the T-tap connector!
Crimping it by hand may result in an unreliable CYP signal.
Crimping it by hand may result in an unreliable CYP signal.

CYP+ Wire Location on the Distributor Connector

Connect the wire from the ignition coil wiring harness to the T-tap Connector.

The distributor is now ready for use with individual ignition coils.